Projects / Ideas / PID temperature controller

PID temperature controller

IntermediateIndustrialIdeaReviewed
In short

How do you build a PID temperature controller?

A PID loop holds a heater at a set temperature for incubators, sous-vide or curing. You need Arduino Nano, DS18B20 waterproof probe, Solid state relay module 2-channel (G3MB-202P), 16x2 LCD with I2C backpack (PCF8574), Rotary encoder module (KY-040) and Resistor 4.7 kΩ.

Level
Intermediate
Time
About 180 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Tune a PID controller.

How to build it

  1. Read temperature
  2. Run PID with time-proportional output
  3. Set the target with the encoder
  4. Tune P, I and D
  5. Add an over-temperature cut-off

Related projects

Common questions

What parts do I need for the PID temperature controller?

Arduino Nano, DS18B20 waterproof probe, Solid state relay module 2-channel (G3MB-202P), 16x2 LCD with I2C backpack (PCF8574), Rotary encoder module (KY-040) and Resistor 4.7 kΩ.

How long does the PID temperature controller take to build?

About 180 minutes for a intermediate maker.