Projects / Ideas / Wave-to-snooze alarm clock

Wave-to-snooze alarm clock

BeginnerHome LabIdeaReviewed
In short

How do you build a wave-to-snooze alarm clock?

An alarm clock that you snooze by waving your hand over an ultrasonic sensor instead of finding a button, and stop for good by pressing the button. The display shows the time and the snooze count. A gentle way to practise alarms and distance sensing. You need Arduino Nano, DS3231 RTC module, HC-SR04 Ultrasonic Sensor, TM1637 4-digit display, Tactile push button 6 mm, Passive buzzer, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 100 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Snooze an alarm with a hand wave.

How to build it

  1. Read the time from the clock chip
  2. Set the alarm time with two button presses
  3. Ring the buzzer at the alarm time
  4. Wave a hand within 15 centimetres to snooze for five minutes
  5. Stop the alarm with the button

Related projects

Common questions

What parts do I need for the wave-to-snooze alarm clock?

Arduino Nano, DS3231 RTC module, HC-SR04 Ultrasonic Sensor, TM1637 4-digit display, Tactile push button 6 mm, Passive buzzer, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the wave-to-snooze alarm clock take to build?

About 100 minutes for a beginner maker.