Idea
In short
How do you build a panel indicator lamp board?
Mount large and wide-angle LEDs in bezels on a small panel with labelled resistors, to learn how indicator lamps are fitted. You need LED holder / bezel 5 mm × 4, LED 10 mm red, Straw hat LED white (5 mm wide angle), Resistor 330 Ω × 2, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 90 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Fit LEDs into a panel.
Parts list
- Optoelectronics
- Optoelectronics
- Optoelectronics
- PassivesResistor 330 Ω × 2
- Power
- Prototyping
How to build it
- Drill the panel
- Fit the bezels
- Wire each LED with a resistor
- Compare the view from the side
- Label the panel
Common questions
What parts do I need for the panel indicator lamp board?
LED holder / bezel 5 mm × 4, LED 10 mm red, Straw hat LED white (5 mm wide angle), Resistor 330 Ω × 2, 5 V 2 A USB adapter and Breadboard 830 Tie Points.
How long does the panel indicator lamp board take to build?
About 90 minutes for a beginner maker.
