Idea
In short
How do you build a touch control panel?
A seven inch serial touch screen has buttons that switch three LEDs and a bar that shows a sensor value. You need Arduino Nano, Nextion 7 inch HMI display, LED 5 mm red × 3, Resistor 220 Ω × 3, Potentiometer 10 kΩ and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 300 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Build a touch control screen.
Parts list
- Development Boards
- Displays
- SemiconductorsLED 5 mm red × 3
- PassivesResistor 220 Ω × 3
- Passives
- Prototyping
How to build it
- Design the screen
- Wire the serial lines
- Send a command
- Read a touch event
- Switch the LEDs
Common questions
What parts do I need for the touch control panel?
Arduino Nano, Nextion 7 inch HMI display, LED 5 mm red × 3, Resistor 220 Ω × 3, Potentiometer 10 kΩ and Breadboard 830 Tie Points.
How long does the touch control panel take to build?
About 300 minutes for a intermediate maker.
