Projects / Ideas / Infrared emissivity tape lab

Infrared emissivity tape lab

BeginnerLearningIdeaReviewed
In short

How do you build an infrared emissivity tape lab?

Point an infrared thermometer at a cup of warm water, once at the shiny side and once at a strip of matt tape, and compare with a probe. You see why an infrared thermometer misreads shiny metal, and how a piece of tape fixes the problem. You need Arduino Nano, MLX90614 infrared thermometer, DS18B20 waterproof probe, Resistor 4.7 kΩ, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 70 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See why shiny things fool an infrared thermometer.

How to build it

  1. Wire the infrared sensor and the probe
  2. Show both readings on the display
  3. Warm a metal cup of water
  4. Aim at the shiny surface and at matt tape
  5. Write down the error each time

Related projects

Common questions

What parts do I need for the infrared emissivity tape lab?

Arduino Nano, MLX90614 infrared thermometer, DS18B20 waterproof probe, Resistor 4.7 kΩ, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the infrared emissivity tape lab take to build?

About 70 minutes for a beginner maker.