Idea
In short
How do you build a single-supply light amplifier?
A rail-to-rail op-amp on a single battery amplifies a small light-sensor signal so a bar of LEDs shows light level. You need MCP6002 rail-to-rail op-amp, LDR Photoresistor, Resistor 10 kΩ × 2, Potentiometer 10 kΩ, LED 5 mm red × 5, Resistor 1 kΩ × 5, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 240 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Amplify a sensor on one supply.
Parts list
- Integrated Circuits
- Sensors
- PassivesResistor 10 kΩ × 2
- Passives
- SemiconductorsLED 5 mm red × 5
- PassivesResistor 1 kΩ × 5
- Batteries
- Power
- Prototyping
How to build it
- Wire the divider
- Add the amplifier
- Set the gain with the pot
- Drive five LEDs
- Check the output range
Common questions
What parts do I need for the single-supply light amplifier?
MCP6002 rail-to-rail op-amp, LDR Photoresistor, Resistor 10 kΩ × 2, Potentiometer 10 kΩ, LED 5 mm red × 5, Resistor 1 kΩ × 5, 9 V battery, 9 V battery snap with DC jack and Breadboard 830 Tie Points.
How long does the single-supply light amplifier take to build?
About 240 minutes for a intermediate maker.
