Idea
In short
How do you build a bare MAX7219 eight-LED bar?
Skip the module and wire the driver chip itself to run eight large LEDs with one resistor setting the current. You need Arduino Nano, MAX7219 LED driver IC, LED 10 mm red × 8, Resistor 10 kΩ, Electrolytic capacitor 10 µF, Ceramic Capacitor 100 nF and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Wire a driver chip from scratch.
Parts list
- Development Boards
- Integrated Circuits
- OptoelectronicsLED 10 mm red × 8
- Passives
- Passives
- Passives
- Prototyping
How to build it
- Read the datasheet pin table
- Set the segment current with one resistor
- Wire the supply capacitors
- Send the display commands
- Light each LED in turn
Common questions
What parts do I need for the bare MAX7219 eight-LED bar?
Arduino Nano, MAX7219 LED driver IC, LED 10 mm red × 8, Resistor 10 kΩ, Electrolytic capacitor 10 µF, Ceramic Capacitor 100 nF and Breadboard 830 Tie Points.
How long does the bare MAX7219 eight-LED bar take to build?
About 180 minutes for a intermediate maker.
