Idea
In short
How do you build a lucky draw LED wheel?
A ring of RGB LEDs spins and slows to stop on a random colour when you press the button. You need Arduino Nano, WS2812B addressable RGB LED strip (1 m, 60 LEDs), Tactile push button 6 mm, Electrolytic Capacitor 100 µF, Resistor 470 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Animate addressable LEDs with easing.
Parts list
- Development Boards
- Optoelectronics
- Switches
- Passives
- Passives
- Prototyping
- Prototyping
How to build it
- Cut or use 16 LEDs of the strip
- Run a spinning pixel
- Slow it with a decay curve
- Stop on a random position
- Add a sound with a passive buzzer
Common questions
What parts do I need for the lucky draw LED wheel?
Arduino Nano, WS2812B addressable RGB LED strip (1 m, 60 LEDs), Tactile push button 6 mm, Electrolytic Capacitor 100 µF, Resistor 470 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the lucky draw LED wheel take to build?
About 150 minutes for a intermediate maker.
