Idea
In short
How do you build a thermometer with a gain stage?
A temperature chip with an op-amp gain stage gives a bigger signal for the ADC, so you see finer steps than the bare chip allows. You need Arduino Nano, LM35 IC (TO-92), LM324 quad op-amp, Resistor 10 kΩ × 2, Resistor 100 kΩ, 9 V battery, 9 V battery snap with DC jack, SSD1306 OLED Display and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Add gain to a sensor.
Parts list
- Development Boards
- Integrated Circuits
- Integrated Circuits
- PassivesResistor 10 kΩ × 2
- Passives
- Batteries
- Power
- Displays
- Prototyping
How to build it
- Read the bare chip first
- Wire the op-amp for gain 11
- Compare the step size
- Check the output stays under 5 V
- Show both on the display
Common questions
What parts do I need for the thermometer with a gain stage?
Arduino Nano, LM35 IC (TO-92), LM324 quad op-amp, Resistor 10 kΩ × 2, Resistor 100 kΩ, 9 V battery, 9 V battery snap with DC jack, SSD1306 OLED Display and Breadboard 830 Tie Points.
How long does the thermometer with a gain stage take to build?
About 150 minutes for a intermediate maker.
