Idea
In short
How do you build a weather mast with surge protection?
A weather mast with wind, rain and temperature sensors uses TVS diodes and proper grounding on every cable to survive nearby lightning. You need ESP32 DevKit V1, TVS diode P6KE6.8A × 4, Polyfuse 2 A, Zener diode 5.1 V (1N4733A) × 2, Optocoupler PC817 × 2 and Waterproof enclosure IP65 (junction box).
- Level
- Advanced
- Time
- About 240 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Protect long sensor cables from surges.
Parts list
- Development Boards
- Semiconductors
- Passives
- Semiconductors
- Semiconductors
- Mechanical & Hardware
How to build it
- Add TVS clamps to each long cable
- Add series resistors and polyfuses
- Isolate the anemometer with optocouplers
- Ground the mast separately from the electronics
- Test clamping with a signal generator
Common questions
What parts do I need for the weather mast with surge protection?
ESP32 DevKit V1, TVS diode P6KE6.8A × 4, Polyfuse 2 A, Zener diode 5.1 V (1N4733A) × 2, Optocoupler PC817 × 2 and Waterproof enclosure IP65 (junction box).
How long does the weather mast with surge protection take to build?
About 240 minutes for a advanced maker.
