Projects / Ideas / 9 V rechargeable discharge curve

9 V rechargeable discharge curve

IntermediatePowerIdeaReviewed
In short

How do you build a 9 V rechargeable discharge curve?

Run a USB-rechargeable 9 V pack into a small resistor and log the voltage for hours to draw its discharge curve. Use a low current and never short it. You need Arduino Nano, 9 V rechargeable Li-ion (USB), Resistor 10 kΩ × 2, Resistor 220 Ω, MicroSD Card Module and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 180 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Log a battery discharge curve.

Parts list

How to build it

  1. Build a two-resistor divider for the pin
  2. Add the small load
  3. Log the voltage each minute
  4. Stop at the cutoff voltage
  5. Plot the curve

Related projects

Common questions

What parts do I need for the 9 V rechargeable discharge curve?

Arduino Nano, 9 V rechargeable Li-ion (USB), Resistor 10 kΩ × 2, Resistor 220 Ω, MicroSD Card Module and Breadboard 830 Tie Points.

How long does the 9 V rechargeable discharge curve take to build?

About 180 minutes for a intermediate maker.