Idea
In short
How do you build a battery discharge curve logger?
A current monitor logs voltage and current of a small cell as it drives a resistor load, then plots the discharge curve. You need Arduino Nano, INA219 Current Monitor, 18650 cell 2600 mAh (branded), Battery holder 18650 single, MicroSD Card Module and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 300 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Log how a cell discharges.
Parts list
- Development Boards
- Sensors
- Batteries
- Power
- Interfaces
- Prototyping
How to build it
- Wire the monitor in series with the load
- Log voltage and current
- Stop at a safe cutoff voltage
- Save to the card
- Plot capacity in milliamp hours
Common questions
What parts do I need for the battery discharge curve logger?
Arduino Nano, INA219 Current Monitor, 18650 cell 2600 mAh (branded), Battery holder 18650 single, MicroSD Card Module and Breadboard 830 Tie Points.
How long does the battery discharge curve logger take to build?
About 300 minutes for a intermediate maker.
