Idea
In short
How do you build a magnet proximity meter?
A linear Hall sensor reads how close a small magnet is and shows a bar that grows as it approaches. You need Arduino Nano, Hall effect sensor module (KY-024, linear), SSD1306 OLED Display and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 150 min
- Parts
- 4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Measure magnet distance.
Parts list
- Development Boards
- Sensors
- Displays
- Prototyping
How to build it
- Wire the sensor
- Read the analogue value
- Find the zero
- Show a bar
- Test north and south
Common questions
What parts do I need for the magnet proximity meter?
Arduino Nano, Hall effect sensor module (KY-024, linear), SSD1306 OLED Display and Breadboard 830 Tie Points.
How long does the magnet proximity meter take to build?
About 150 minutes for a beginner maker.
