How do you build an IR learning remote?
Point a TV remote at the receiver, press a button and the Nano records its code, then three buttons on your own box send back the saved codes through an infrared LED. A great way to see how remotes work. Only use it with your own devices. You need Arduino Nano, IR receiver VS1838B, IR LED 940 nm (5 mm), BC547 NPN transistor, Resistor 1 kΩ, Resistor 220 Ω, Tactile push button 6 mm × 3, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 100 min
- Parts
- 9
Record and replay a remote control's codes.
Parts list
- Development Boards
- Sensors
- Optoelectronics
- Semiconductors
- Passives
- Passives
- Switches
- Prototyping
- Prototyping
How to build it
- Read the incoming code from the receiver
- Save it for one of three buttons
- Send the code through the IR LED
- Drive the LED with a transistor
- Test it on your own TV or fan
Common questions
What parts do I need for the IR learning remote?
Arduino Nano, IR receiver VS1838B, IR LED 940 nm (5 mm), BC547 NPN transistor, Resistor 1 kΩ, Resistor 220 Ω, Tactile push button 6 mm × 3, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the IR learning remote take to build?
About 100 minutes for a intermediate maker.
