Idea
In short
How do you build an AC scheduler with an IR blaster?
An ESP32 learns your AC remote's codes and sends them on a schedule, for example 26 °C at bedtime and off at 5 am. You need ESP32 DevKit V1, IR receiver VS1838B, IR LED 940 nm (5 mm) × 2, BC547 NPN transistor, Resistor 47 Ω, Resistor 1 kΩ and AHT20 temperature and humidity sensor.
- Level
- Advanced
- Time
- About 240 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Capture and replay long infrared AC codes.
Parts list
- Development Boards
- Sensors
- Optoelectronics
- Semiconductors
- Passives
- Passives
- Sensors
How to build it
- Capture your AC's codes with the IRremoteESP8266 dump example
- Drive two IR LEDs through a transistor for more range
- Send the right code at set times
- Read room temperature to skip a step if it is already cool
- Show the schedule on a web page
Common questions
What parts do I need for the AC scheduler with an IR blaster?
ESP32 DevKit V1, IR receiver VS1838B, IR LED 940 nm (5 mm) × 2, BC547 NPN transistor, Resistor 47 Ω, Resistor 1 kΩ and AHT20 temperature and humidity sensor.
How long does the AC scheduler with an IR blaster take to build?
About 240 minutes for a advanced maker.
