Idea
In short
How do you build a haunted box?
Lift your hand near a decorated box and a motion sensor sets off a spooky sound clip and a flickering red light. A fun party prop, and a simple way to meet sound modules. Keep the volume low and tell visitors about it first, so nobody is startled badly. You need Arduino Nano, PIR Motion Sensor HC-SR501, DFPlayer Mini MP3 module, Speaker 8 Ω 0.5 W, LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 80 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Trigger a spooky sound when someone gets close.
Parts list
- Development Boards
- Sensors
- Interfaces
- Motors & Actuators
- Semiconductors
- Passives
- Prototyping
- Prototyping
How to build it
- Let the motion sensor settle after power-up
- Play a sound when it triggers
- Flicker the LED while it plays
- Wait before it can trigger again
- Set a safe volume level
Common questions
What parts do I need for the haunted box?
Arduino Nano, PIR Motion Sensor HC-SR501, DFPlayer Mini MP3 module, Speaker 8 Ω 0.5 W, LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the haunted box take to build?
About 80 minutes for a beginner maker.
