Projects / Ideas / Hand-launch glider g-force logger

Hand-launch glider g-force logger

IntermediateDrones & RCIdeaReviewed
In short

How do you build a hand-launch glider g-force logger?

A small ADXL345 logger rides in a foam hand-launch glider and records the shock of the throw and the landing to a memory card. You see how hard a launch really is and how well your glider is built to survive it. Fly in an open field, away from people and roads. You need Raspberry Pi Pico H, ADXL345 accelerometer, Micro SD card module (SPI, 3.3 V), Battery holder 2 × AA, AA alkaline battery × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 130 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Record how hard a glider is thrown and lands.

How to build it

  1. Wire the accelerometer and card on the Pico
  2. Log fast samples to the card
  3. Test by hand with small shakes
  4. Fix it in a glider with its weight balanced
  5. Read the file and find launch and landing peaks

Related projects

Common questions

What parts do I need for the hand-launch glider g-force logger?

Raspberry Pi Pico H, ADXL345 accelerometer, Micro SD card module (SPI, 3.3 V), Battery holder 2 × AA, AA alkaline battery × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the hand-launch glider g-force logger take to build?

About 130 minutes for a intermediate maker.