Idea
In short
How do you build a touch-sensitive glow wand?
Touch a metal ring and a wand changes colour, a toy introduction to capacitive touch. You need Arduino Nano, Touch sensor module (TTP223), RGB LED 5 mm common cathode, Resistor 220 Ω × 3, Li-Po battery 3.7 V 1000 mAh, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Beginner
- Time
- About 100 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Use a touch sensor to change an RGB colour.
Parts list
- Development Boards
- Sensors
- Semiconductors
- PassivesResistor 220 Ω × 3
- Batteries
- Prototyping
- Prototyping
How to build it
- Wire the touch module
- Wire the common-cathode RGB LED
- Cycle colours on each touch
- Fade smoothly between colours
- Add a hold-to-turn-off action
Related projects
Common questions
What parts do I need for the touch-sensitive glow wand?
Arduino Nano, Touch sensor module (TTP223), RGB LED 5 mm common cathode, Resistor 220 Ω × 3, Li-Po battery 3.7 V 1000 mAh, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the touch-sensitive glow wand take to build?
About 100 minutes for a beginner maker.
