Projects / Ideas / Gesture-controlled lamp

Gesture-controlled lamp

IntermediateSmart HomeIdeaReviewed
In short

How do you build a gesture-controlled lamp?

Swipe a hand over a gesture sensor to turn a low-voltage lamp on, off or change its brightness. You need Arduino Nano, APDS-9960 gesture, colour and proximity sensor, WS2812B addressable RGB LED strip (1 m, 60 LEDs), Electrolytic Capacitor 100 µF, Resistor 470 Ω and 5 V 3 A USB buck module (12/24 V to USB).

Level
Intermediate
Time
About 180 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Read gestures from an I2C sensor.

How to build it

  1. Read gesture events
  2. Map up and down to brightness
  3. Map left and right to colour
  4. Show the mode on a status LED
  5. Add a timeout

Related projects

Common questions

What parts do I need for the gesture-controlled lamp?

Arduino Nano, APDS-9960 gesture, colour and proximity sensor, WS2812B addressable RGB LED strip (1 m, 60 LEDs), Electrolytic Capacitor 100 µF, Resistor 470 Ω and 5 V 3 A USB buck module (12/24 V to USB).

How long does the gesture-controlled lamp take to build?

About 180 minutes for a intermediate maker.