Projects / Ideas / Freezer thaw logger

Freezer thaw logger

IntermediateHome LabIdeaReviewed
In short

How do you build a freezer thaw logger?

A waterproof temperature probe sits in a freezer, a Nano logs the readings with a time stamp, and an LED turns on if the temperature goes above a limit for a while. It shows after the fact whether a power cut warmed the freezer. Indicative only, never a food-safety device, so use your own judgement and a proper thermometer. You need Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, DS3231 RTC module, MicroSD Card Module, LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
9
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Log freezer temperature through a power cut.

How to build it

  1. Read the probe with a pull-up resistor
  2. Keep the time from the clock module
  3. Write readings to the SD card
  4. Light the LED above the limit
  5. Plot the file on a computer

Related projects

Common questions

What parts do I need for the freezer thaw logger?

Arduino Nano, DS18B20 waterproof probe, Resistor 4.7 kΩ, DS3231 RTC module, MicroSD Card Module, LED 5 mm red, Resistor 220 Ω, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the freezer thaw logger take to build?

About 100 minutes for a intermediate maker.