Idea
In short
How do you build a feather ESP32-S3 deep sleep logger?
An Adafruit Feather ESP32-S3 wakes from deep sleep every few minutes, reads a sensor, stores the value in memory that survives sleep and shows the history over serial. Power it over USB only; no charging of lithium cells is used in this build. You need Adafruit Feather ESP32-S3, BME280 Environmental Sensor and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 150 min
- Parts
- 3
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn deep sleep and data that survives it.
Parts list
- Development Boards
- Sensors
- Prototyping
How to build it
- Wire the sensor on I2C
- Read the sensor on each wake
- Store the value in RTC memory
- Go back to deep sleep
- Print the stored history when asked
Common questions
What parts do I need for the feather ESP32-S3 deep sleep logger?
Adafruit Feather ESP32-S3, BME280 Environmental Sensor and Breadboard 830 Tie Points.
How long does the feather ESP32-S3 deep sleep logger take to build?
About 150 minutes for a intermediate maker.
