Idea
In short
How do you build an ESP32-S3 Wi-Fi mood lamp?
An ESP32-S3 serves a small colour picker page on your home network that sets the colour and brightness of a WS2812B LED strip. Keep the strip short and the brightness low to limit current. You need ESP32-S3 DevKitC-1, WS2812B strip 5 m (30 LEDs/m) and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 160 min
- Parts
- 3
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Set a lamp colour from a phone page.
Parts list
- Development Boards
- Optoelectronics
- Prototyping
How to build it
- Wire the strip data pin through a small resistor
- Serve a page with a colour input
- Read the chosen colour
- Set the strip and a brightness limit
- Remember the last colour
Common questions
What parts do I need for the ESP32-S3 Wi-Fi mood lamp?
ESP32-S3 DevKitC-1, WS2812B strip 5 m (30 LEDs/m) and Breadboard 830 Tie Points.
How long does the ESP32-S3 Wi-Fi mood lamp take to build?
About 160 minutes for a intermediate maker.
