Idea
In short
How do you build an ESP32-S3 I2S tone generator?
An ESP32-S3 sends a sine wave over I2S to a PCM5102A DAC module, with the pitch chosen over serial. Connect the line output to an amplifier or headphone amp, never straight to a speaker. You need ESP32-S3 DevKitC-1, PCM5102A I2S DAC and Breadboard 830 Tie Points.
- Level
- Advanced
- Time
- About 200 min
- Parts
- 3
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Make a clean test tone from a digital audio DAC.
Parts list
- Development Boards
- Integrated Circuits
- Prototyping
How to build it
- Wire the DAC to the I2S pins
- Make a table of sine samples
- Stream samples to the I2S driver
- Change the pitch from serial commands
- Check the output level
Common questions
What parts do I need for the ESP32-S3 I2S tone generator?
ESP32-S3 DevKitC-1, PCM5102A I2S DAC and Breadboard 830 Tie Points.
How long does the ESP32-S3 I2S tone generator take to build?
About 200 minutes for a advanced maker.
