Idea
In short
How do you build a fence voltage tester and break alarm?
A safe, isolated pick-up coil senses the pulses of an existing farm fence energiser and alarms when they stop because the fence is broken. You need Arduino Nano, Enamelled copper wire (magnet wire, 0.3 mm), Signal Diode 1N4148, Optocoupler PC817, Active buzzer 5 V and Resistor 1 kΩ.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Sense high-voltage pulses without contact using induction and an optocoupler.
Parts list
- Development Boards
- Cables & Wires
- Semiconductors
- Semiconductors
- Motors & Actuators
- Passives
How to build it
- Wind a coil and place it beside (not touching) the fence wire
- Rectify the pulses into the optocoupler LED
- Count pulses on the Nano side, which stays isolated
- Alarm when no pulse comes for 5 s
- Never connect anything directly to an energised fence
Common questions
What parts do I need for the fence voltage tester and break alarm?
Arduino Nano, Enamelled copper wire (magnet wire, 0.3 mm), Signal Diode 1N4148, Optocoupler PC817, Active buzzer 5 V and Resistor 1 kΩ.
How long does the fence voltage tester and break alarm take to build?
About 180 minutes for a intermediate maker.
