Projects / Ideas / Diode clipper and clamper lab

Diode clipper and clamper lab

IntermediateAnalog CircuitsIdeaReviewed
In short

How do you build a diode clipper and clamper lab?

A square wave from the Nano passes through a diode and a capacitor to show a clipper trimming the top of a signal and a clamper shifting it up or down, measured with a multimeter and the Nano's own analogue input. A neat link between a diode and a real signal. You need Arduino Nano, Signal Diode 1N4148 × 2, Electrolytic capacitor 10 µF, Resistor 10 kΩ × 2, Potentiometer 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 90 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Trim and shift a signal with diodes.

How to build it

  1. Make a square wave on a Nano pin
  2. Pass it through a diode to ground as a clipper
  3. Add a capacitor and diode as a clamper
  4. Read the levels with the analogue input
  5. Plot input against output on paper

Related projects

Common questions

What parts do I need for the diode clipper and clamper lab?

Arduino Nano, Signal Diode 1N4148 × 2, Electrolytic capacitor 10 µF, Resistor 10 kΩ × 2, Potentiometer 10 kΩ, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the diode clipper and clamper lab take to build?

About 90 minutes for a intermediate maker.