Projects / Ideas / Cube probe telemetry

Cube probe telemetry

IntermediateCommunicationIdeaReviewed
In short

How do you build a cube probe telemetry?

A small probe in a card cube measures temperature, pressure and humidity and sends them over ESP-NOW to a ground board with a screen, the way a student satellite sends telemetry. Watch the numbers change as you lift the probe or warm it with your hand. You need ESP32 DevKit V1 × 2, BME280 Environmental Sensor, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Send sensor readings to a ground station.

How to build it

  1. Read the sensor on the probe board
  2. Pack the numbers into a message
  3. Send it every two seconds
  4. Show the values on the ground board
  5. Flag a lost link after ten seconds

Related projects

Common questions

What parts do I need for the cube probe telemetry?

ESP32 DevKit V1 × 2, BME280 Environmental Sensor, SSD1306 OLED Display, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the cube probe telemetry take to build?

About 100 minutes for a intermediate maker.