Idea
In short
How do you build a CAN bus priority demo?
Two Nano boards with CAN modules both try to send at the same moment, and the message with the lower ID wins while the other waits its turn. Print what each board sees. It is the neat idea that lets cars share one pair of wires safely. You need Arduino Nano × 2, MCP2515 CAN bus module × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 90 min
- Parts
- 4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
See how CAN lets the lower ID win.
Parts list
- Development BoardsArduino Nano × 2
- Interfaces
- Prototyping
- Prototyping
How to build it
- Wire both modules to the SPI pins
- Give the boards two different message IDs
- Send on both at once
- Print the order that arrives
- Swap the IDs and repeat
Common questions
What parts do I need for the CAN bus priority demo?
Arduino Nano × 2, MCP2515 CAN bus module × 2, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the CAN bus priority demo take to build?
About 90 minutes for a intermediate maker.
