Projects / Ideas / Tap and double-tap detector

Tap and double-tap detector

IntermediateLearningIdeaReviewed
In short

How do you build a tap and double-tap detector?

An accelerometer with built-in tap detection counts single and double taps on a table, using its interrupt pin. You need Arduino Nano, ADXL345 accelerometer, SSD1306 OLED Display and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 240 min
Parts
4
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Use hardware tap detection.

Parts list

How to build it

  1. Wire the sensor on I2C
  2. Set the tap threshold
  3. Read the interrupt source
  4. Count single and double taps
  5. Show the counts

Related projects

Common questions

What parts do I need for the tap and double-tap detector?

Arduino Nano, ADXL345 accelerometer, SSD1306 OLED Display and Breadboard 830 Tie Points.

How long does the tap and double-tap detector take to build?

About 240 minutes for a intermediate maker.