Lab / KTU / Analog and linear ICs / Experiment 8

Wien bridge oscillator

Analog and linear ICsVirtual readings4 viva questionsRecord book ready
Open virtual bench
Aim

To design and test a Wien bridge oscillator and measure its frequency.

Apparatus
  • IC 741
  • Resistors 10 kΩ × 2 (bridge), Rf and R1 for gain
  • Capacitors 0.01 µF × 2
  • Dual supply ±12 V
  • CRO
Av ≈ 48

Theory

The Wien network (series RC and parallel RC) has zero phase shift at f = 1/(2πRC) and passes one-third of the signal there. A non-inverting amplifier with gain 3 (Rf = 2R1) keeps oscillation going. In practice the gain is set slightly above 3, and a lamp, diodes or a JFET stabilise the amplitude.

Circuit connections
  • Output → series R and C → pin 3; parallel R and C from pin 3 to ground; Rf from pin 6 to 2, R1 from pin 2 to ground

Procedure

Pre-lab check

4 questions · 75% to be ready
1What is the phase shift of the Wien network at f0?
2Why is the amplifier non-inverting?
3How is the amplitude stabilised?
4How is a Wien bridge oscillator tuned?

Try the readings before the lab

Calculated, not measured. In the lab, write down your own readings.
QuantityValue
f = 1 / (2πRC)1 kHz
Required gain3 (Rf = 2·R1)

Precautions

  • Too much gain gives a clipped, square-ish output; too little and it stops.

My readings

Type what you measured. It goes into your record book, and to My Garage when you are signed in.

S. No.QuantityValue
1
2
3
4
5
6

Check my readings

Put the value you set in the first column, then compare. Real parts have tolerance.

Open my record book
Result

Designed frequency ___ Hz, measured ___ Hz.

Everything above is free. The print-ready write-up comes with Maker.

Printed pages leave the observation table empty for your own readings.

Viva questions

Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.

1. What is the phase shift of the Wien network at f0?
2. Why is the amplifier non-inverting?
3. How is the amplitude stabilised?
4. How is a Wien bridge oscillator tuned?

Quick answers for your record and viva

What is the aim of the wien bridge oscillator experiment?

To design and test a Wien bridge oscillator and measure its frequency.

What apparatus is needed for wien bridge oscillator?

IC 741, Resistors 10 kΩ × 2 (bridge), Rf and R1 for gain, Capacitors 0.01 µF × 2, Dual supply ±12 V, CRO.

What is the theory behind wien bridge oscillator?

The Wien network (series RC and parallel RC) has zero phase shift at f = 1/(2πRC) and passes one-third of the signal there. A non-inverting amplifier with gain 3 (Rf = 2R1) keeps oscillation going. In practice the gain is set slightly above 3, and a lamp, diodes or a JFET stabilise the amplitude.

What result should I get in wien bridge oscillator?

Designed frequency ___ Hz, measured ___ Hz.

What precautions should I take in wien bridge oscillator?

Too much gain gives a clipped, square-ish output; too little and it stops.

Wien bridge oscillator: lab experiment, theory and viva