Lab / AKTU / Circuits and measurements / Experiment 5

Verification of the superposition theorem

Circuits and measurementsVirtual readings4 viva questionsRecord book ready
Open virtual bench
Aim

To verify that the current in a branch of a linear circuit with two sources equals the sum of the currents due to each source acting alone.

Apparatus
  • Two DC supplies
  • Resistors 1 kΩ, 2.2 kΩ, 3.3 kΩ
  • Multimeter
Vout = 2.5 V

Theory

In a linear network with several sources, the response in any branch is the algebraic sum of the responses caused by each source acting alone, with the others replaced by their internal resistance (a voltage source by a short).

Read the lesson: Resistor networks ›
Circuit connections
  • V1 → R1 → node N ← R2 ← V2; R3 from N to ground; measure I3 through R3

Procedure

Pre-lab check

4 questions · 75% to be ready
1Can superposition be used to find power?
2How is a current source removed?
3Why must the circuit be linear?
4Give a use of superposition.

Try the readings before the lab

Calculated, not measured. In the lab, write down your own readings.
ConditionNode voltage (V)I3 (mA)
V1 alone5.691.724
V2 alone1.2930.392
Sum of the two6.9832.116
Both sources6.9832.116

Precautions

  • Short a removed source with a wire, not by turning the knob to 0 V on a supply with output protection.
  • Keep the direction of current the same in every reading.

My readings

Type what you measured. It goes into your record book, and to My Garage when you are signed in.

S. No.ConditionNode voltage (V)I3 (mA)
1
2
3
4
5
6

Check my readings

Put the value you set in the first column, then compare. Real parts have tolerance.

Open my record book
Result

I3 with both sources = ___ mA; I3′ + I3″ = ___ mA. They are equal, so the superposition theorem is verified.

Everything above is free. The print-ready write-up comes with Maker.

Printed pages leave the observation table empty for your own readings.

Viva questions

Say your answer out loud first, then check. The first 2 answers are free; Maker opens all 4.

1. Can superposition be used to find power?
2. How is a current source removed?
3. Why must the circuit be linear?
4. Give a use of superposition.

Quick answers for your record and viva

What is the aim of the verification of the superposition theorem experiment?

To verify that the current in a branch of a linear circuit with two sources equals the sum of the currents due to each source acting alone.

What apparatus is needed for verification of the superposition theorem?

Two DC supplies, Resistors 1 kΩ, 2.2 kΩ, 3.3 kΩ, Multimeter.

What is the theory behind verification of the superposition theorem?

In a linear network with several sources, the response in any branch is the algebraic sum of the responses caused by each source acting alone, with the others replaced by their internal resistance (a voltage source by a short).

What result should I get in verification of the superposition theorem?

I3 with both sources = ___ mA; I3′ + I3″ = ___ mA. They are equal, so the superposition theorem is verified.

What precautions should I take in verification of the superposition theorem?

Short a removed source with a wire, not by turning the knob to 0 V on a supply with output protection. Keep the direction of current the same in every reading.

Verification of the superposition theorem: lab experiment