Components / Wireless / SIM800L GSM module

SIM800L GSM module

Small 2G modem for SMS, calls and GPRS.

RadioGSM / GPRS quad-band
Band850 / 900 / 1800 / 1900 MHz
InterfaceUART AT commands
Supply voltage3.4 to 4.4 V, peaks of 2 A
WirelessReviewedMPN SIM800LUsed in 14 projects
SIM800L
In short

What is the SIM800L GSM module and what is it used for?

Small 2G modem for SMS, calls and GPRS. Makers use it for SMS alerts.

How it works

A quad-band GSM and GPRS modem controlled with AT commands over serial.

Key specifications

Wireless module specValue
RadioGSM / GPRS quad-band
Band850 / 900 / 1800 / 1900 MHz
InterfaceUART AT commands
Supply voltage3.4 to 4.4 V, peaks of 2 A
Logic level2.8 V
Watch out for2G service is being switched off by many Indian operators: check yours, or use a 4G module

Pinout

VCC3.4 to 4.4 V, 2 A peaks
GNDGround
RXDFrom the board's TX (2.8 V logic, use a divider from 5 V)
TXDTo the board's RX
RSTReset (active low)
NETAntenna
SPK MICSpeaker and microphone pairs

How to use it

Power it from a Li-ion cell or a buck converter set to 4.0 V with a 1000 µF capacitor, never from the Arduino 5 V pin. The LED blinks every second while searching and every 3 seconds once registered. It is 2G only, and Jio has no 2G network.

Applications

Alternatives

Buy at

Common questions

What is the SIM800L GSM module used for?

In maker projects: SMS alerts.

How does the SIM800L GSM module work?

A quad-band GSM and GPRS modem controlled with AT commands over serial.

What voltage does the SIM800L GSM module need?

3.4 to 4.4 V, peaks of 2 A.

How do I connect the SIM800L GSM module to an Arduino or ESP32?

UART AT commands. Pins: VCC (3.4 to 4.4 V, 2 A peaks), GND (Ground), RXD (From the board's TX (2.8 V logic, use a divider from 5 V)), TXD (To the board's RX), RST (Reset (active low)), NET (Antenna).

What can I use instead of the SIM800L GSM module?

SIM A7670C 4G module and SIM7600 4G LTE module.