MPU6500 6-axis IMU
Newer 6-axis accelerometer and gyro, close to the MPU6050.
MeasuresAcceleration and rotation
InterfaceI2C or SPI
I2C address0x68 or 0x69
Supply voltage1.71 to 3.6 V
SensorsReviewedMPN MPU-6500Used in 1 project
In short
What is the MPU6500 6-axis IMU and what is it used for?
Newer 6-axis accelerometer and gyro, close to the MPU6050. Makers use it for balancing robots.
How it works
A MEMS accelerometer and gyroscope with a digital motion processor.
Key specifications
| Sensor spec | Value |
|---|---|
| Measures | Acceleration and rotation |
| Interface | I2C or SPI |
| I2C address | 0x68 or 0x69 |
| Supply voltage | 1.71 to 3.6 V |
Pinout
VCC3.3 V
GNDGround
SCLI2C or SPI clock
SDAI2C data or SPI MOSI
AD0Address 0x68 or 0x69, or SPI MISO
INTInterrupt
NCSSPI chip select
How to use it
Register-compatible with the MPU6050 for most uses, but check the WHO_AM_I value (0x70) because some libraries reject it. SPI allows much faster reads than I2C.
Applications
Balancing robots
Builds that use it
Alternatives
- MPU6050 IMUThe most widely documented IMU
- BMI160 6-axis IMULow-power alternative
Common questions
What is the MPU6500 6-axis IMU used for?
In maker projects: balancing robots.
How does the MPU6500 6-axis IMU work?
A MEMS accelerometer and gyroscope with a digital motion processor.
What voltage does the MPU6500 6-axis IMU need?
1.71 to 3.6 V.
How do I connect the MPU6500 6-axis IMU to an Arduino or ESP32?
I2C or SPI. Pins: VCC (3.3 V), GND (Ground), SCL (I2C or SPI clock), SDA (I2C data or SPI MOSI), AD0 (Address 0x68 or 0x69, or SPI MISO), INT (Interrupt).
What can I use instead of the MPU6500 6-axis IMU?
MPU6050 IMU and BMI160 6-axis IMU.
