Components / Sensors / Hall Effect Sensor A3144

Hall Effect Sensor A3144

Switch responds to suitable magnetic field conditions.

MeasuresMagnetic field (south pole), on/off
RangeSwitches at roughly 7 to 35 mT
AccuracyDigital switch with hysteresis
InterfaceOpen-collector output, needs 10 kΩ pull-up
SensorsReviewedMPN A3144Used in 20 projects
A3144
In short

What is the Hall Effect Sensor A3144 and what is it used for?

Switch responds to suitable magnetic field conditions. Makers use it for count magnet passes.

Not 3.3 V: the minimum supply is 4.5 V. Use INPUT_PULLUP to the board's own logic level.
In the real world

Rotation and magnet detection

How it works

Sensors convert a physical quantity into an electrical signal. Calibrate, verify module supply, interfaces and environmental limits.

Key specifications

Sensor specValue
MeasuresMagnetic field (south pole), on/off
RangeSwitches at roughly 7 to 35 mT
AccuracyDigital switch with hysteresis
InterfaceOpen-collector output, needs 10 kΩ pull-up
Supply voltage4.5 to 24 V
Operating temperature−40 to 85 °C

Pinout

1VCC4.5 to 24 V (left, printed face toward you)
2GNDGround
3OUTPulls LOW near a magnet; pull-up needed

How to use it

Output goes LOW when a magnet's south pole is near the printed face. Count wheel turns by gluing a small magnet to the wheel.

void setup() { Serial.begin(9600); pinMode(2, INPUT_PULLUP); }
void loop() { Serial.println(digitalRead(2) == LOW ? "magnet" : "-"); delay(100); }

Applications

Buy at

Common questions

What is the Hall Effect Sensor A3144 used for?

In products: rotation and magnet detection. In maker projects: count magnet passes.

How does the Hall Effect Sensor A3144 work?

Sensors convert a physical quantity into an electrical signal. Calibrate, verify module supply, interfaces and environmental limits.

What voltage does the Hall Effect Sensor A3144 need?

4.5 to 24 V.

How do I connect the Hall Effect Sensor A3144 to an Arduino or ESP32?

Open-collector output, needs 10 kΩ pull-up. Pins: 1 VCC (4.5 to 24 V (left, printed face toward you)), 2 GND (Ground), 3 OUT (Pulls LOW near a magnet; pull-up needed).