Idea
In short
How do you build a workshop dust monitor?
A Sharp dust sensor watches dust in a carpentry or 3D print room and shows a bar when you should open a door or run the extractor. You need Arduino Nano, GP2Y1014AU dust sensor, SSD1306 OLED Display, Resistor 330 Ω and Electrolytic capacitor 220 µF.
- Level
- Intermediate
- Time
- About 120 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Pulse an LED and sample the analog output at the right instant.
Parts list
- Development Boards
- Sensors
- Displays
- Passives
- Passives
How to build it
- Wire the sensor with its 150 ohm and 220 uF network
- Sample 0.28 ms after the LED pulse
- Convert to micrograms per cubic metre
- Smooth with a moving average
- Show a bar graph
Common questions
What parts do I need for the workshop dust monitor?
Arduino Nano, GP2Y1014AU dust sensor, SSD1306 OLED Display, Resistor 330 Ω and Electrolytic capacitor 220 µF.
How long does the workshop dust monitor take to build?
About 120 minutes for a intermediate maker.
