CCS811 air quality sensor
TVOC and eCO2 sensor. Now end-of-life, replaced by the ENS160.
MeasuresTVOC and eCO2 (estimated)
InterfaceI2C
I2C address0x5A or 0x5B
Supply voltage1.8 to 3.6 V
SensorsReviewedMPN CCS811Used in 2 projects
In short
What is the CCS811 air quality sensor and what is it used for?
TVOC and eCO2 sensor. Now end-of-life, replaced by the ENS160. Makers use it for air quality demos.
How it works
A metal-oxide gas sensor with a microcontroller that estimates eCO2 and TVOC.
Key specifications
| Sensor spec | Value |
|---|---|
| Measures | TVOC and eCO2 (estimated) |
| Interface | I2C |
| I2C address | 0x5A or 0x5B |
| Supply voltage | 1.8 to 3.6 V |
Pinout
VIN3.3 V (some modules 5 V)
GNDGround
SCLI2C clock
SDAI2C data
WAKEPull low to wake
INTInterrupt
RSTReset
ADDAddress 0x5A or 0x5B
How to use it
Tie WAKE low. It needs 48 hours of first burn-in and 20 minutes of warm-up each time. It is discontinued, so prefer the ENS160 or SGP40 for new designs.
Applications
Air quality demos
Builds that use it
Alternatives
- ENS160 air quality sensorCurrent replacement
Common questions
What is the CCS811 air quality sensor used for?
In maker projects: air quality demos.
How does the CCS811 air quality sensor work?
A metal-oxide gas sensor with a microcontroller that estimates eCO2 and TVOC.
What voltage does the CCS811 air quality sensor need?
1.8 to 3.6 V.
How do I connect the CCS811 air quality sensor to an Arduino or ESP32?
I2C. Pins: VIN (3.3 V (some modules 5 V)), GND (Ground), SCL (I2C clock), SDA (I2C data), WAKE (Pull low to wake), INT (Interrupt).
What can I use instead of the CCS811 air quality sensor?
ENS160 air quality sensor.
