Tools / DC Copper-Wire Voltage Drop

How to work out the voltage drop in a wire

Every wire has a little resistance, and current across it loses voltage. Here is the working with your numbers.

R = ρ(2L)/A; ΔV = IR; ρ≈0.017241 Ω·mm²/m at 20°C

Inputs

m
mm²
A

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Loop resistance (approx.)
137.9 mΩ
Voltage drop (approx.)
137.9 mV
Power loss (approx.)
137.9 mW
What this leaves out
  • Copper DC at approximately 20°C; excludes connectors, temperature changes, AC effects and conductor ampacity.
Step by step

The working with your numbers

  1. The round trip is twice the lengthLength = 2 × 2 m = 4 mCurrent goes out along one wire and back along the other.
  2. Resistance of the copperR = ρ × L ÷ A = 0.017241 × 4 ÷ 0.5 = 138 mΩ
  3. Voltage dropΔV = I × R = 1 × 0.138 = 0.138 V
  4. Heat in the wireP = I² × R = 138 mW

Does the answer make sense?

  • OK: 2 A per mm². Under about 4 is comfortable in a bundle and 6 is the limit in free air.
  • OK: For a 5 V supply this is 2.76 % lost, for 12 V 1.15 %. The lower the supply, the bigger the proportion.

Pick a real part

  • 0.5 mm² is about 20 AWG. The wire gauge calculator gives the gauge for your current.

Common mistakes

  • Using the one-way length. The current also comes back.
  • Forgetting that thin leads and long runs cost the most on a low supply voltage such as 5 V.
  • Using the area of one strand of stranded wire instead of the whole conductor.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

How do you work out voltage drop in a wire?

ΔV = I × R, with R = 0.017241 × (2 × length) ÷ area for copper in Ω, m and mm². 1 A in 2 m of 0.5 mm² wire drops 0.017241 × 4 ÷ 0.5 = 0.138 V.

How much voltage drop is acceptable?

Keep it under 3 to 5 % of the supply for power wiring, and under 2 % for anything sensitive like a motor or an LED strip at the far end.