Tools / Standard resistor value finder
How to pick standard resistor values
Resistors only come in preferred values. Here is how to find the closest one, and what to do when it is not close enough.
Nearest E-series value, then the best two-resistor series or parallel pair
Result
- Nearest value
- 3 kΩ
- Error
- -4.459 %
- Next lower
- 3 kΩ
- Next higher
- 3.3 kΩ
- Tolerance range
- 2.85 kΩ to 3.15 kΩ at ±5 %
- Series pair
- 130 Ω + 3 kΩ = 3.13 kΩ
- Series pair error
- -0.3185 %
- Parallel pair
- 3.9 kΩ ∥ 16 kΩ = 3.14 kΩ
- Parallel pair error
- -0.1376 %
What this leaves out
- The nearest single value is further off than half the series tolerance (5 %). A pair may suit better.
Step by step
The working with your numbers
- Scale your value to between 1 and 10
3.14 kΩ ÷ 1,000 = 3.14Every series repeats the same 6, 12, 24, 48 or 96 numbers in each decade, so only the first digits matter. - Find the two neighbours in E24
below = 3 kΩ, above = 3.3 kΩ - Take the closer one
nearest = 3 kΩ, error = (3,000 − 3,140) ÷ 3,140 = −4.46 % - Add the tolerance band
A ±5 % part is really between 2.85 kΩ and 3.15 kΩThe series is spaced so that neighbouring bands just touch.
Does the answer make sense?
- OK: The error is inside the ±5 % the part is sold at, so the part's own spread is bigger than the rounding.
Pick a real part
- Best two in series: 130 Ω + 3 kΩ = 3.13 kΩ.
- Best two in parallel: 3.9 kΩ ∥ 16 kΩ = 3.14 kΩ.
- A pair also shares the power, so two ¼ W parts in parallel can carry about ½ W.
Common mistakes
- Rounding up when the circuit needs a minimum. For an LED resistor go up; for a base resistor go down. Choose the direction before the nearest.
- Using E12 values with 1 % resistors. A 1 % part is normally from E96, so you can have 4.99 k, not just 4.7 k.
- Ignoring the tolerance. The part you pick is only guaranteed to be within its band, so the nearest value is not exactly what you get.
Learn it, try it, build it
Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.
Common questions
What are E12 and E24 resistor values?
They are the preferred numbers resistors are made in. E12 has 12 values per decade (1.0, 1.2, 1.5, 1.8, 2.2, 2.7, 3.3, 3.9, 4.7, 5.6, 6.8, 8.2) with 10 % tolerance, and E24 has 24 values with 5 %.
What do I do when no standard resistor gives the value I need?
Put two in series (the values add) or in parallel (the total is below the smaller one) and pick the pair closest to your target. A finer series such as E96 also helps.
