Tools / RC Time Constant

How to work out an RC time constant

A resistor slows how fast a capacitor fills. R × C tells you how slow. Here is the working with your numbers.

τ = RC; approx. 63.2% at one τ

Inputs

Ω
µF

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Time constant
1 s
Three tau
3 s
Five tau
5 s
Step by step

The working with your numbers

  1. Change the capacitance to faradsC = 100 µF ÷ 1,000,000 = 10⁻⁴ F
  2. Multiply R by Cτ = R × C = 10,000 × 10⁻⁴ = 1 sτ (tau) is the time constant, in seconds.
  3. After one τ the capacitor is at 63 %1 s → 63 % of the supply
  4. After three τ it is at 95 %3τ = 3 s → 95 %
  5. After five τ it counts as full5τ = 5 s → 99.3 %
  6. Time to reach any levelt = −τ × ln(1 − level) → 50 % at 693 ms, 90 % at 2.3 s, 99 % at 4.6 sFor a threshold such as a logic input at 70 % of the supply, use the RC charge and discharge calculator.
  7. Worst case with ±1 % R and ±20 % Cτ between 792 ms and 1.21 s
See it

How the capacitor charges

0 %50 %100 %0 s2 s4 sTimeτ, 63 %
ChargingDischargingCapacitor voltage against time. After one time constant (1 s) it reaches 63 %; after 5τ it is above 99 %.

Does the answer make sense?

  • OK: Units check: ohms × farads = seconds. Doubling R or C doubles τ to 2 s.
  • OK: Each τ closes 63 % of the gap that is left, so the curve slows down as it gets closer to full. That is why it never quite reaches 100 %.

Pick a real part

  • Electrolytic capacitors are often ±20 %, so in real life τ can be anywhere from 800 ms to 1.2 s.
  • Nearest standard parts: R = 10 kΩ, C = 100 µF.

Common mistakes

  • Forgetting to change µF to farads. 10 kΩ × 100 gives 1,000,000 s instead of 1 s.
  • Thinking the capacitor is full after one time constant. It is only at 63 %. Use 5τ for full.
  • Forgetting the capacitor's tolerance. ±20 % on C means ±20 % on the time.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Just need the number? Use the RC time constant calculator on Geekobot.

Common questions

How do you work out an RC time constant?

Multiply the resistance in ohms by the capacitance in farads. 10 kΩ and 100 µF give 10,000 × 0.0001 = 1 second.

How long does a capacitor take to charge fully?

About five time constants. After one τ it is at 63 %, after three at 95 % and after five at 99.3 %, which counts as full.