Tools / Ideal Inverting Amplifier

How to work out an inverting op-amp gain

The minus input is held at 0 V, so the input current has to flow through the feedback resistor. Here is the working with your numbers.

Gain = −Rf/Rin, ideal linear amplifier

Inputs

Ω
Ω
V

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Ideal gain
-10 V
Ideal output
-1 V
What this leaves out
  • Ideal closed-loop gain only; supply rails, common-mode, output swing, gain-bandwidth, stability and slew rate not checked.
Step by step

The working with your numbers

  1. The minus input sits at 0 V (virtual ground)V− = V+ = 0 V
  2. So the input current isI = Vin ÷ Rin = 0.1 ÷ 1,000 = 100 µA
  3. That same current flows through RfVout = 0 − I × Rf = −100 µA × 10 kΩ = −1 V
  4. So the gain isGain = −Rf ÷ Rin = −10,000 ÷ 1,000 = −10

Does the answer make sense?

  • OK: The minus sign means the output is upside down: a positive input gives a negative output.
  • OK: The input source sees only Rin (1 kΩ), so a weak source may need a bigger Rin or a buffer in front.
  • OK: The output needs a supply that reaches −1 V plus about 1.5 V of headroom. On a single supply, bias the + input at half the supply.

Pick a real part

  • Nearest standard values: Rf = 10 kΩ, Rin = 1 kΩ, gain −10.

Common mistakes

  • Dropping the minus sign. On a single 0 to 5 V supply the output cannot go negative, so it just sits at 0 V.
  • Making Rin small for more gain and then overloading the signal source.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

How do you work out the gain of an inverting amplifier?

Gain = −Rf ÷ Rin. 10 kΩ and 1 kΩ give a gain of −10, so 0.1 V in gives −1 V out.

Why is the output of an inverting amplifier negative?

Current flows into the virtual-ground minus input and out through Rf, so the output has to go below 0 V to pull it. It needs a negative supply, or a mid-supply bias on a single supply.