Tools / Op-amp gain with standard resistors

How to choose op-amp gain resistors from standard values

The ideal Rf is rarely a real resistor. This finds the nearest one and shows what that does to the gain and bandwidth.

Non-inverting: Rf = (G − 1)·Rg; inverting: Rf = G·Rg; bandwidth = GBW ÷ noise gain

Inputs

×
Ω
%
MHz

Results update as you type. Prefixes work: 4.7k, 100u, 10n.

Result
Standard rf
100 kΩ
Ideal rf
100 kΩ
Actual gain
11 V
Gain error
0 %
Lowest gain
10.8 V
Highest gain
11.2 V
Bandwidth
90.91 kHz
Step by step

The working with your numbers

  1. Ideal feedback resistorRf = (G − 1) × Rg = (11 − 1) × 10,000 = 100 kΩ
  2. Nearest E24 valueRf = 100 kΩ
  3. The gain you actually getG = 1 + Rf ÷ Rg = 1 + 100,000 ÷ 10,000 = 11Error 0 % from rounding the resistor.
  4. Worst case with ±1 % resistors|G| between 10.8 to 11.2
  5. Bandwidthf(−3 dB) ≈ GBW ÷ noise gain = 1,000,000 ÷ 11 = 90.9 kHzFor non-inverting, noise gain equals the signal gain.

Does the answer make sense?

  • OK: Rounding alone changes the gain by 0 %.
  • OK: You keep 90.9 kHz of bandwidth. A signal at the top of your band should be at most about a tenth of it for 1 % accuracy.
  • OK: Rf = 100 kΩ is in the sensible 1 kΩ to 1 MΩ range.

Pick a real part

  • For gain 11 with an LM358 (about 1 MHz) the bandwidth falls to about 90.9 kHz. A faster part (TL072 at 3 MHz, MCP6002 at 1 MHz) helps.
  • For better gain accuracy than rounding allows, trim Rg too: use a pair such as 10 kΩ (E96) with an E96 Rf.

Common mistakes

  • Using the closed-loop gain to find the bandwidth for an inverting stage. The noise gain is one higher.
  • Picking resistors so large that bias current and noise matter, or so small that they load the output.
  • Forgetting that the non-inverting gain starts at 1. For gain under 1 use an inverting stage or a divider.

Learn it, try it, build it

Calculated, not measured. Check the exact part datasheet and your real circuit before powering anything.

Common questions

How do you choose op-amp gain resistors?

Non-inverting: Rf = (G − 1) × Rg. Inverting: Rf = G × Rg. Pick Rg from 1 kΩ to 100 kΩ, compute Rf, then take the nearest value in E24 or E96. For gain 11 with Rg = 10 kΩ, Rf = 100 kΩ.

Why is my op-amp bandwidth lower than expected?

The gain-bandwidth product is fixed, so bandwidth = GBW ÷ noise gain. A 1 MHz op-amp at gain 11 only gives about 90 kHz.