Idea
In short
How do you build a line follower PID lab?
You tune a PID controller on a small line follower and compare it with simple left-right logic. You need Arduino Nano, TT gear motor 3 to 6 V × 2, L9110S dual motor driver, TCRT5000 IR reflective sensor module × 3, Robot car chassis kit 2WD (acrylic) and 9 V battery.
- Level
- Advanced
- Time
- About 420 min
- Parts
- 6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Learn control tuning on a robot.
Parts list
- Development Boards
- Motors & Actuators
- Motor Drivers
- Sensors
- Mechanical & Hardware
- Batteries
How to build it
- Read three sensors
- Compute a line position
- Steer with simple logic
- Add proportional control
- Add derivative control and compare
Common questions
What parts do I need for the line follower PID lab?
Arduino Nano, TT gear motor 3 to 6 V × 2, L9110S dual motor driver, TCRT5000 IR reflective sensor module × 3, Robot car chassis kit 2WD (acrylic) and 9 V battery.
How long does the line follower PID lab take to build?
About 420 minutes for a advanced maker.
