Idea
In short
How do you build a keypad box with a solenoid latch?
A small box opens a solenoid latch when the right code is typed. A learning box for a craft case, not a door lock for valuables. You need Arduino Nano, Solenoid lock 12 V, TIP120 Darlington transistor, Rectifier Diode 1N4007, Resistor 1 kΩ, 12 V 2 A DC adapter and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 270 min
- Parts
- 7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Open a latch with a code.
Parts list
- Development Boards
- Motors & Actuators
- Semiconductors
- Semiconductors
- Passives
- Power
- Prototyping
How to build it
- Wire the driver and diode
- Test the latch
- Read a keypad
- Compare to a code
- Close after a few seconds
Common questions
What parts do I need for the keypad box with a solenoid latch?
Arduino Nano, Solenoid lock 12 V, TIP120 Darlington transistor, Rectifier Diode 1N4007, Resistor 1 kΩ, 12 V 2 A DC adapter and Breadboard 830 Tie Points.
How long does the keypad box with a solenoid latch take to build?
About 270 minutes for a intermediate maker.
