Projects / Ideas / Servo tilt maze

Servo tilt maze

IntermediateGames & ToysIdeaReviewed
In short

How do you build a servo tilt maze?

Two servos tilt a card maze in two directions to roll a marble to the exit, steered by a motion sensor in your hand so a tilt of your hand tilts the maze. A friendly mix of motion sensing, servos and a game. Keep the marble large enough that nobody can swallow it, and away from small children. You need Arduino Nano, MPU6050 IMU, SG90 Micro Servo × 2, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Intermediate
Time
About 100 min
Parts
7
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Steer a marble through a maze by tilting your hand.

How to build it

  1. Read the tilt of the hand-held sensor
  2. Map the tilt to two servo angles
  3. Limit the angles so the maze stays gentle
  4. Smooth the movement
  5. Add a calm and a quick mode

Related projects

Common questions

What parts do I need for the servo tilt maze?

Arduino Nano, MPU6050 IMU, SG90 Micro Servo × 2, Battery holder 4 × AA with switch, AA alkaline battery × 4, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the servo tilt maze take to build?

About 100 minutes for a intermediate maker.