Projects / Ideas / Potentiometer taper explorer

Potentiometer taper explorer

BeginnerLearningIdeaReviewed
In short

How do you build a potentiometer taper explorer?

Wire a linear pot, a slide pot and a multi-turn pot as dividers, turn each in equal steps and note the output with a multimeter. You see how the track and the wiper position shape the voltage, and why a volume control feels different from a dimmer. You need Potentiometer 10 kΩ, Slide potentiometer 10 kΩ, Multi-turn potentiometer 10 kΩ (3590S), Potentiometer 1 kΩ (linear), 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 40 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

See how the shape of a pot's track changes what your hand feels.

How to build it

  1. Wire the first pot as a divider across the battery
  2. Turn it in ten equal steps and write the voltages
  3. Repeat for the slide pot and the multi-turn pot
  4. Plot all three on one sheet
  5. Compare the steps and note where each is easy to set

Related projects

Common questions

What parts do I need for the potentiometer taper explorer?

Potentiometer 10 kΩ, Slide potentiometer 10 kΩ, Multi-turn potentiometer 10 kΩ (3590S), Potentiometer 1 kΩ (linear), 9 V battery, 9 V battery snap with DC jack, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the potentiometer taper explorer take to build?

About 40 minutes for a beginner maker.