Projects / Ideas / Model escalator step lights

Model escalator step lights

BeginnerLightingIdeaReviewed
In short

How do you build a model escalator step lights?

A strip of LEDs runs a chase down a model escalator when something passes the sensor at the bottom, and fades out a short time after it passes. A simple way to learn lighting effects with a sensor trigger. Keep the model low voltage and dry. You need Arduino Nano, WS2812B addressable RGB LED strip (1 m, 60 LEDs), IR obstacle avoidance sensor module, Resistor 330 Ω, Electrolytic capacitor 1000 µF, 5 V 2 A USB adapter, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

Level
Beginner
Time
About 80 min
Parts
8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Run lights down a model escalator when someone arrives.

How to build it

  1. Wire the strip with a resistor and capacitor
  2. Wait for the sensor to trigger
  3. Run a bright step down the strip
  4. Fade out after a few seconds
  5. Run it in the other direction with a button

Related projects

Common questions

What parts do I need for the model escalator step lights?

Arduino Nano, WS2812B addressable RGB LED strip (1 m, 60 LEDs), IR obstacle avoidance sensor module, Resistor 330 Ω, Electrolytic capacitor 1000 µF, 5 V 2 A USB adapter, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).

How long does the model escalator step lights take to build?

About 80 minutes for a beginner maker.