Projects / Ideas / Two-board CAN message link

Two-board CAN message link

IntermediateCommunicationIdeaReviewed
In short

How do you build a two-board CAN message link?

Two boards send small messages over a twisted pair using a CAN controller and a transceiver, and a counter shows lost frames. You need Arduino Nano × 2, MCP2515 CAN controller × 2, TJA1050 CAN transceiver × 2, Resistor 100 kΩ and Breadboard 830 Tie Points.

Level
Intermediate
Time
About 210 min
Parts
5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Build a small CAN link.

Parts list

How to build it

  1. Wire each controller on SPI
  2. Add the transceivers
  3. Add termination at both ends
  4. Send a counter
  5. Count missed frames when you add noise

Related projects

Common questions

What parts do I need for the two-board CAN message link?

Arduino Nano × 2, MCP2515 CAN controller × 2, TJA1050 CAN transceiver × 2, Resistor 100 kΩ and Breadboard 830 Tie Points.

How long does the two-board CAN message link take to build?

About 210 minutes for a intermediate maker.