Projects / Ideas / IV drip rate monitor model

IV drip rate monitor model

IntermediateHealthIdeaReviewed
In short

How do you build an IV drip rate monitor model?

An IR sensor counts drops in a drip chamber and alarms if flow stops or runs too fast. You need Arduino Nano, Slotted optical switch (H21A1), SSD1306 OLED Display, Active buzzer 5 V, Resistor 220 Ω and Resistor 10 kΩ.

Level
Intermediate
Time
About 150 min
Parts
6
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal

Count fast optical events and compute a rate.

Parts list

How to build it

  1. Clip the sensor around the drip chamber
  2. Count drops with an interrupt
  3. Work out drops per minute
  4. Alarm when outside the set range
  5. Practise with water only

Related projects

Common questions

What parts do I need for the IV drip rate monitor model?

Arduino Nano, Slotted optical switch (H21A1), SSD1306 OLED Display, Active buzzer 5 V, Resistor 220 Ω and Resistor 10 kΩ.

How long does the IV drip rate monitor model take to build?

About 150 minutes for a intermediate maker.