Idea
In short
How do you build a PCB etching timer?
A countdown timer for etching a PCB beeps every 30 seconds as a reminder to agitate the tray and when time is up. Gloves, goggles and ventilation are a must; keep the timer away from the chemicals. You need Arduino Nano, SSD1306 OLED Display, Tactile push button 6 mm × 2, Passive buzzer and Breadboard 830 Tie Points.
- Level
- Beginner
- Time
- About 100 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Time and pace an etching session.
Parts list
- Development Boards
- Displays
- Switches
- Motors & Actuators
- Prototyping
How to build it
- Set the etch time with two buttons
- Count down on the display
- Beep every 30 seconds to agitate
- Sound an alarm at the end
- Remind to rinse and neutralise
Common questions
What parts do I need for the PCB etching timer?
Arduino Nano, SSD1306 OLED Display, Tactile push button 6 mm × 2, Passive buzzer and Breadboard 830 Tie Points.
How long does the PCB etching timer take to build?
About 100 minutes for a beginner maker.
