Idea
In short
How do you build an encoder speed and position readout?
A 600 pulse encoder on a hand-turned shaft gives position, direction and speed, and shows them on a display. You need Arduino Nano, Incremental rotary encoder 600 PPR, SSD1306 OLED Display, Resistor 10 kΩ × 2 and Breadboard 830 Tie Points.
- Level
- Intermediate
- Time
- About 180 min
- Parts
- 5
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Read a fine encoder.
Parts list
- Development Boards
- Sensors
- Displays
- PassivesResistor 10 kΩ × 2
- Prototyping
How to build it
- Wire the A and B lines
- Count with interrupts
- Show position and direction
- Work out speed
- Reset with a button
Common questions
What parts do I need for the encoder speed and position readout?
Arduino Nano, Incremental rotary encoder 600 PPR, SSD1306 OLED Display, Resistor 10 kΩ × 2 and Breadboard 830 Tie Points.
How long does the encoder speed and position readout take to build?
About 180 minutes for a intermediate maker.
