Idea
In short
How do you build a phone keypad tone maker?
Press a key on a keypad and the Nano plays the two tones that an old phone made for that key, mixed through two resistors into a small amplifier. You hear how each key has its own pair of notes. Keep the volume low. You need Arduino Nano, 4x4 matrix keypad (membrane), Resistor 10 kΩ × 2, Ceramic Capacitor 100 nF, LM386 amplifier module, Speaker 8 Ω 0.5 W, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
- Level
- Intermediate
- Time
- About 90 min
- Parts
- 8
An idea, not a guided build yet. Goal, parts and steps; no wiring, code or tests. Copy it to My Garage to plan it.
Goal
Make the two-tone sounds of phone keys.
Parts list
- Development Boards
- Switches
- PassivesResistor 10 kΩ × 2
- Passives
- Audio
- Motors & Actuators
- Prototyping
- Prototyping
How to build it
- Read the keypad
- Look up the row and column tones
- Make each tone with a timer pin
- Mix the two through resistors
- Play each for a short beep
Common questions
What parts do I need for the phone keypad tone maker?
Arduino Nano, 4x4 matrix keypad (membrane), Resistor 10 kΩ × 2, Ceramic Capacitor 100 nF, LM386 amplifier module, Speaker 8 Ω 0.5 W, Breadboard 830 Tie Points and Jumper wires male to male (40 pcs, 20 cm).
How long does the phone keypad tone maker take to build?
About 90 minutes for a intermediate maker.
